Tianjin CFS Technology Co., Ltd

 

 

 

 

Adjust the height of the handle to make the manpower pull down the best state, pull down the handle, lift the whole base, support the foot to the ground smoothly, and then let go.

Diamond polishing pad is recommended. When installing the polishing pad, paste the polishing pad directly onto the polishing disc.

After the polishing mat is installed, step on the supporting part with your foot, hold the handle with your hand, and slowly turn the machine forward so that the whole machine is stable on the ground.

Turn on the start switch, run from low speed to high speed, and observe whether the machine is normal and smooth. The speed is adjusted to the ground condition, and the best speed is 1500-1800 in general. Low speed polishing, the effect will not be obvious.

 

 

http://www.cfsgrinder.com/